Art & Craft Comparisons · Reviewed November 13, 2026
Scor-Buddy vs Scor-Pal Eighths: Which Scoring Board?
A three-inch square thank-you note starts with a six-inch strip. A three-inch cube needs a much larger blank. Buy the Scor-Buddy for the notes you cut before card club; choose the full Scor-Pal for sheets you want to lay out, score and turn without part of the design hanging off the board. The distance between grooves is the same.
Best for
Paper crafters choosing an inch-based hand scoring board for greeting cards, place cards, accordion inserts or folded boxes.
Probably not for
Anyone looking for a paper trimmer, a cutting mat, a metric grid or a machine that cuts, creases and folds a stack automatically.
Specifications at a glance
| At the craft table | Scor-Buddy SP106 | Scor-Pal SP108 |
|---|---|---|
| Scoring surface, not overall footprint | About 7 × 6¾ inches | 12 × 12 inches |
| Regular groove spacing | ⅛ inch | ⅛ inch |
| 4 × 6-inch note blank; fold at 3 inches | Entire blank fits | Entire blank fits |
| 8½ × 5½-inch card blank; fold at 4¼ inches | Fold fits; far edge overhangs | Entire blank fits |
| 12 × 4-inch strip; folds every 2 inches | Cannot reach all five from one edge in one setup | All five scores from a single reference edge |
| 9-inch square tray blank | Too large to support the whole blank | Fits in either orientation |
| Scoring implement | Snap-in Scor-Tool; mini carry tote supplied | Scor-Tool stores on board |
As an Amazon Associate I earn from qualifying purchases.
Scor-Buddy Eighths Mini Scoring Board, Inches (SP106)
A compact inch board with a left fence, grooves every eighth of an inch and a scoring tool that snaps into its holder. The matching tote is included.
Pros
- Fully supports small folded notes and gift enclosures
- Board and scoring tool can travel together in the supplied tote
Cons
- A half sheet of US letter paper extends past the scoring area
- Some multi-panel layouts require a second alignment
Who it’s for: Choose it for a shared table or travel bag when most blanks are already cut and the intended creases fit the mini surface.
Check Scor-Buddy Eighths Mini Scoring Board, Inches (SP106) on Amazon Paid linkScor-Pal Eighths 12 × 12-Inch Scoring Board (SP108)
The inch Eighths board has a square working area and raised edges along the top and both sides. Its ruler identifies common card folds, including the center and two sides of an A2 gatefold.
Pros
- Takes a 12-inch square scrapbook sheet without overhang
- Lets you mark several parallel folds without losing the original reference edge
Cons
- Needs desk space for the board beyond the 12-inch scoring area
- Adds no finer regular groove spacing for small notes
Who it’s for: Choose it if you routinely bring whole sheets, score long concertina strips or turn square box blanks.
Check Scor-Pal Eighths 12 × 12-Inch Scoring Board (SP108) on Amazon Paid linkMeasure the open card, then turn it toward the groove
Start with a 4 × 6-inch rectangle and make a note that opens like a book. Put the six-inch dimension across the ruler. The center is three inches in, and the tool travels only four inches to make the hinge. The entire job fits on the mini: you can hold one panel against the fence while drawing the score down the other side of your hand. A dozen such notes need no more surface than one. Batch size alone is a poor reason to carry the larger board.
A US A2 greeting card offers a more interesting choice. To make a side-opening card, cut a blank 8½ inches across by 5½ inches high. Register the left edge and score at 4¼ inches. Both boards have that groove, and both have enough length for the 5½-inch stroke. The far end of the blank extends off the mini, which need not matter if the table there is clear. On the full Scor-Pal the whole blank lies within the scoring area. Neither board requires that you cut an A2 card smaller.
Now turn the design into a top-opening card with the same finished face. The flat blank is 4¼ by 11 inches, not 5½ by 8½. The new score is at 5½ across a stroke just 4¼ inches long. That is still possible on the mini, but even more of the blank extends to the side. Check the space beside your board, particularly if you work next to an open ink pad. The board that fits in the tote does not make the paper any shorter.
Count the folds that share one reference edge
Picture a six-panel accordion insert for a travel journal. Begin with a 12 × 4-inch strip and make panels two inches wide. That gives five crease positions, at 2, 4, 6, 8 and 10 inches from the left. With the SP108 the strip fits straight across. The four-inch tool stroke does not change; you simply move along the ruler. Pencil a small mark on the back of the first panel so you know which panel gets glued to the journal after the alternating folds are made.
The SP106 can reach 2, 4 and 6 inches from the first end. For the other two lines you can turn the strip end for end and use 2 and 4 inches from what was the far edge. That works because the strip is exactly 12 inches and the design is symmetric. If your strip came out 11⅞ inches long, the two scores made from the other end no longer fall at 8 and 10 inches from the original edge. A sample might hide the difference; the edge of a printed panel could make it quite visible.
For a gatefold, return to the 8½-inch-wide A2 blank. Score at 2⅛ and 6⅜ inches. The two outside panels are then each 2⅛ inches wide and meet over the 4¼-inch center. Both coordinates land on the mini ruler. The SP108 supports the far edge of the sheet and Scor-Pal identifies those two measurements for gatefolds. Buy the larger board for this layout if the support matters to you; there is no need to buy it just because the instructions contain eighths.
Size a box from its blank, not from its floor
Suppose you want an open paper tray with a five-inch square floor and two-inch walls. Before allowing for how the corners join, draw the flat layout: two inches of wall, five inches of floor and another two inches of wall. The stock is a nine-inch square. On the SP108, mark the lines at two and seven inches, rotate the sheet a quarter turn and repeat. Both pairs of opposite walls come from the same measurements. The four corner squares are still present; you need to cut and attach tabs according to your chosen tray pattern.
On the mini, seven inches is already at or beyond the working boundary, and a nine-inch stroke cannot be supported in one pass. Simply turning the sheet and measuring two inches from each edge solves only half the problem. It locates the walls, but it does not make a groove long enough to carry the tool from top to bottom. If trays like this are a regular project, choose the full board. Conversely, for a three-inch floor with one-inch walls, the flat square is only five inches across. All four wall lines then fit comfortably on the Buddy.
A square sheet matters as much as a square board. If a pair of walls leans inward when the paper is folded, first compare the two opposite edges of an unused blank. Scoring preserves the edge you used as your reference; it does not straighten a crooked cut. If what you need is a way to cut the blanks to size in the first place, the Dahle rotary paper trimmer comparison covers that part of the job. Keep the cutting operation off the bare scoring grooves.
What to pack for a card swap or a shared worktable
If everyone at a card swap receives a packet of precut 3 × 6-inch blanks, the Buddy leaves room for the things people will actually share: stamps, ink, envelopes and a sample card. Send the scoring tool home in the holder, not loose among strips of similar-colored paper. A mini board makes less sense at the preparation table the night before, where someone may be trimming a stack of letter sheets, scoring larger inserts and laying out two versions of the same card.
For place settings, decide whether you need to score anything at all. A hand-lettered tent cut from plain cardstock needs a fold placed to suit its face; the scoring board earns its place. A room full of computer-printed names may instead call for ready-to-fold printable blanks. The Avery printable tent card comparison matches two face sizes to a tabletop. It is a different purchase from a board, but it may remove a whole operation if printed names are the only project on your list.
Before packing a board you already own, look at the channels, not just the color. Scor-Pal describes an older light-blue full-size board with quarter-inch spacing; its light-blue Eighths successor has channels every eighth. The manufacturer also identifies its updated Eighths Buddy separately from the older mini. A quarter-inch board will handle the three-inch note. It is the wrong board to count on for the gatefold recipe above unless you plan another way to set the eighth-inch positions.
Read the crease before blaming the board size
A deep furrow is not the goal. The hinge should bend where you intended without a cut running through its length. Scor-Pal recommends holding the scoring tool at about 45 degrees and working with its side rather than digging in with the point. Use an offcut from the same sheet to judge how much pressure produces a useful fold, particularly before scoring a card front you have already printed. A larger board will not fix a line that tears because you pressed too hard.
For the final decision, set the flat blank for your most frequent project on the table and trace the longest crease with a finger. Is the paper that falls outside a seven-inch square just a flap, or does the crease itself leave the square? In the first case, the SP106 can be enough. In the second, or when you need to reach several remote grooves without turning the sheet, choose the SP108. If you need millimeter positions throughout or a board that trims along the same track, neither of these two inch-based scorers is the right match.
Official sources and further reading
Sources reviewed on November 13, 2026. Prices, availability and terms can change; recheck before buying.
- Scor-Pal: Scor-Buddy Eighths model 106 working area, grooves, tool and carry tote
- Scor-Pal: Scor-Pal Eighths model 108 surface, raised edges and gatefold positions
- Scor-Pal: full-size Eighths scoring tool storage and separate mat accessory
- Scor-Pal FAQ: full-size board generations and scoring tool technique
- Amazon US: Scor-Buddy Mini Scoring Board, 6.75 × 7 inches, 1/8-inch grooves Paid link
- Amazon US: Scor-Pal Scoring Board, 12 × 12 inches, 1/8-inch grooves Paid link
Commission disclaimer
This article contains affiliate links. If you buy or sign up through one of them, I may earn a commission at no extra cost to you. That commission does not change the price you pay or the criteria used in this guide. Product details, prices, availability, and terms can change, so confirm the current information on the linked page before buying.