Laynie Hasan.

← All offer guides

Music & Hobby Comparisons · Reviewed November 12, 2026

PureSound P1420 vs S1430: 20 or 30 Snare Wire Strands?

If you like the sound of your 20-strand setup and need fresh wires, start with the PureSound Custom P1420. Choose the Super 30 S1430 if you want the wires to play a bigger part in each note and your drum has the bed to accommodate them. Both are for a 14-inch drum; only the Super 30 carries a specific recommendation for a 3 to 3.5-inch-wide snare bed.

Best for

A drummer replacing the under-head wires on a conventional 14-inch acoustic snare, or deciding whether to change its wire response.

Probably not for

A smaller drum, a drum with a proprietary snare frame, or an electronic pad. Neither set includes a new drumhead or repairs a sticking throw-off.

Specifications at a glance

Manufacturer specifications for the exact versions compared
What to checkPureSound Custom P1420PureSound Super 30 S1430
Drum diameter14 inches14 inches
Wire assembly20 evenly spaced steel coils30 evenly spaced steel coils
Wire gaugeMediumMedium
Bed widthNo numerical target on the Custom product page; verify the drum takes a standard setMaker recommends a 3 to 3.5-inch-wide bed
Reason to choose itKeep a familiar 20-strand balance between the drum note and wire soundBring out the wire sound on a compatible drum

As an Amazon Associate I earn from qualifying purchases.

PureSound Custom Series P1420, 14-Inch 20-Strand Snare Wire

Twenty medium-gauge steel coils span the bottom head. This is the original Custom series, not the similarly named Custom Pro.

Pros

  • Keeps the count unchanged when replacing an old 20-strand set
  • Leaves more room in the overall sound for the drum note than the 30-strand option

Cons

  • Not the first choice if the point of the swap is a wider spread of wires
  • A matching diameter alone does not establish a fit on special frames

Who it’s for: Use it on a compatible house snare whose sound already works for the room, but whose existing wires are bent or damaged.

Check PureSound Custom Series P1420, 14-Inch 20-Strand Snare Wire on Amazon

PureSound Super 30 S1430, 14-Inch 30-Strand Snare Wire

Thirty medium-gauge steel coils form a wider set. PureSound designed it to make the snares more prominent without switching wire material.

Pros

  • Adds ten strands when moving from a 20-strand set
  • Maker gives a bed-width target to check before ordering

Cons

  • Needs a bed suited to the wider set
  • A stronger wire sound is a drawback if the aim is to hear more of the drum itself

Who it’s for: Consider it for a compatible 14-inch snare when you like its open note but want a more obvious wire response once the throw-off is engaged.

Check PureSound Super 30 S1430, 14-Inch 30-Strand Snare Wire on Amazon

Is the sound you want to change coming from the wires?

Play one stroke in the middle of the drum with the snare lever on, then release the lever and play the same stroke again. The second note still has a pitch and a tail, but it loses the sizzle of the wires against the lower head. Which sound bothers you? If it is the high ringing note that is still there with the lever off, neither set is a sensible first purchase. If you like that note but want a different proportion of rattle when the lever is on, you have a reason to look at strand count.

A damaged set poses a different question from a healthy set that sounds too polite. Suppose the house snare sounded right for years and only started rattling after someone packed it against a loose stand. Look underneath for a coil that bows away from its neighbors or a strap that has slipped sideways. If the wires are damaged, count them before throwing them out. Replacing a familiar 20-strand set with the P1420 changes one fewer thing. If a strap has merely slipped and the wires are intact, recenter the set before ordering a replacement.

Fourteen inches tells you the length category, not the bed width

The drum diameter and the snare bed width are two measurements taken in different directions. A 14-inch drum takes a wire assembly intended to stretch across a 14-inch head. The bed is the shallow dip in the lower edge of the shell where the end of that assembly sits; there is a matching dip at the opposite end. Its width runs across the row of wires, not along them. The space between the two straps, the length of the end plate and the depth of the shell are not substitutes for that measurement.

Imagine choosing wires for two 14-inch drums at school. One maker lists a bed width of 3.25 inches. That puts it inside the range PureSound recommends for the S1430. The other drum is labeled 14 by 6.5 inches. That 6.5 describes shell depth; you still know nothing about its bed width. Look up the exact drum model or ask its maker before choosing the wider set. There is no need to take apart a borrowed drum to settle a shopping question, and no reason to alter the edge of a good shell to accommodate replacement wires.

Listen for the drum note behind the backbeat

Think of two parts on the same drum. In a sparse verse, a backbeat lands after the bass has stopped. You can hear the body of the note and the brief rustle on top of it. If the relationship already suits the song, the P1420 is a sensible replacement for standard 20-strand wires. Later, with guitars playing through the backbeat, you may want the rustle itself to be more distinct. On a suitable bed, the S1430 makes sense for that specific change. It is the contribution of the wires you are choosing, not a guaranteed increase in the volume of the kit.

The common steel construction helps narrow the decision. You are not comparing a brass wire with a steel wire, or a straight concert cable with a coil. Nor does ten extra strands mean that a quiet stroke will sound half again as loud. Head choice, tuning, playing position and tension all affect the note. If you can ask a bandmate to listen from out front, give them the musical question: can they hear the soft snare answer between the two loud accents? Their answer is more useful than whether they like the drum in isolation.

Brush swish comes from the playing surface

A brush player might ask for more swish on a ballad. A circular sweep moves the brush tips across the playing surface. The P1420 and S1430 sit underneath the other head; neither renews a worn patch on top or changes the width of the brush fan. If the sweep is faint but tapped notes already have enough snare sound, look at the surface and the brushes first. The Vic Firth Heritage and Jazz wire brush comparison addresses the implement in your hand rather than the wires underneath the shell.

The same distinction matters at a head change. The batter head is the one you strike; the snare-side head is the one the wires touch. If your project is to change the feel at the stick or the amount of ring on top, the Remo Ambassador and Emperor coated snare head comparison covers two batter heads, not replacements for that thin lower head. When possible, change the head and wires on different days. Otherwise you may end up crediting the extra strands for a change that remains even when the wires are switched off.

A straight pull matters on either set

Before undoing the old straps, take a picture that shows both ends and the lever. The fixed clamp at one end and the moving strainer at the other need to pull the wire assembly along the same line. EVANS recommends starting with the tension adjustment near the middle of its travel. That leaves room to adjust in either direction once the new set is mounted. Center the assembly so that neither end plate touches the edge of the shell, and attach the strainer end with the lever off. Follow the drum maker’s instructions for its particular clamps.

Look along the rows before you put the drum back on its stand. If one end plate is pointing toward a lug while the other is square, loosen and align the set. Tightening a crooked assembly is not the same as straightening it. Once aligned, engage the lever and listen to soft taps as well as accented hits while adjusting tension. Stop at a setting that lets both speak the way you want. If the lever will only close with unusual force, do not pull harder; release it and check the mounting and adjustment before continuing.

When neither of these 14-inch sets belongs on the drum

A matching number on an old case is a poor substitute for identifying what is inside it. For example, PureSound lists separate replacement assemblies for the Rogers Dyna-Sonic and the Ludwig Super Sensitive. If your drum uses a dedicated snare carrier or a mechanism that moves both ends of the wires, start with the drum model and hardware generation. A standard P1420 is not a safe default simply because it has fewer strands than the Super 30. On a rental or a vintage instrument, let the owner or a drum technician confirm the part.

Finally, read the code as well as the count. For these two choices the 14-inch Custom is P1420, not CPS1420, which denotes a Custom Pro. Super 30 is a family name: it also appears on sets for smaller drums. Look specifically for S1430 when buying for the compatible 14-inch shell. Once those checks are out of the way, the decision is simple: preserve a 20-strand sound you already like, or choose the wider set because you actually want to hear more wire in the note.

Official sources and further reading

Sources reviewed on November 12, 2026. Prices, availability and terms can change; recheck before buying.

Commission disclaimer

This article contains affiliate links. If you buy or sign up through one of them, I may earn a commission at no extra cost to you. That commission does not change the price you pay or the criteria used in this guide. Product details, prices, availability, and terms can change, so confirm the current information on the linked page before buying.